Bidet AB-6000 Installation

 Bidet AB-6000 Installation Instructions

Water connection:
1. Turn off the valve that supplies water to the toilet tank.

2. Empty the toilet tank by flushing it.

3. Remove the hose connecting the water supply valve with the toilet tank, and replace it with the “Flexible Hose”. included in the box (Part #1), if needed.

4. Hand tighten the “Metal T Connector” (Part #2) to the connection on the bottom of toilet tank, being sure to place the conic rubber washer (Part #3) is inside the “Metal T Connector”.

5. Hand tighten, the “Flexible Hose”, to the other end of the “Metal T Connector”, and to the water valve at the wall.

Bidet Installation:
1. Using the Flat Screwdriver, and the Wrench if needed, remove the bolts and nuts, and take out the toilet seat and cover.

2. Take out the Installation base (Part #6), from the bottom of the bidet AB-6000, pressing down and slicing.

3. Place the installation base aligning the “Sliding Seat Adjusters”(Part #4), place thru holes and fixed with the bolts and nuts (Part #5) by hand.

4. Place the bidet seat on the "Installation Base" along with the toilet bowl. Be sure that the bidet is fixed on the base.

For more details, see instructions included with the product.

 Bidet AB-6000 Instructions for Use

1. Seat on the toilet; select the nozzle you want to use turning the knob selector of nozzles and self cleaning to the right or to the left, Turn ON the “Water Pressure Knob”, slowly turning to the right, until reaches comfortable pressure for required cleanness. Adjust pressure to the comfort level.

2. “Self Cleaning System”: after use, select nozzle cleaning in the knob selector of nozzles and self cleaning, turn the “Water Pressure Knob” to activate the “Self Cleaning System” that will clean the “Nozzle” surface. Return the knob to the center position to turn off the water.

WARNING: Be careful to turn the “Water Pressure” knob very slowly until the comfortable pressure is reached.

Back to Top