Bidet BB-2000 Installation

 Bidet BB-2000 Installation Instructions

1. Shut off the incoming water to the toilet at the wall valve and drain the toilet's water tank by flushing it.

2. Remove the existing water hose or pipe that connects the wall valve to the toilet tank and replace it with the “Flexible Hose” included in the box, hand-tightening it to the “Metal T-Connector” that must be attached to the connection at the bottom of the toilet tank. Don't over tighten it, placing the 7/8” conical “Black Rubber Washer” inside the “Metal T-Connector”. Make sure to put the rubber washer or the system will leak.

3. Remove the toilet seat and cover by unscrewing the bolts and nuts using a flat-head screwdriver.

4. Place a large flat “Black Rubber Washer” on each bolt hole and place the bidet on top of them, aligning the “Sliding Seat Adjusters” with the holes.

5. Set the toilet seat and cover on top of the bidet and reinsert and tighten the bolts and nuts securing everything in position.

6. Measure and cut the flexible plastic tube needed to connect the bidet's water inlet to the “Metal T-Connector” on the toilet tank.

7. After installation, open the water valve and allow the water pass through the system.

9. Slowly turn the bidet’s “Water Pressure” knob to the right to open the valve and remove the stagnant water.

10. Select the desired position of the “Nozzle” with the “Nozzle Selection” knob.

You're done installing your new Blue Bidet. Congratulate yourself and enjoy the Natural Cleansing Power of Water.

For more details, see instructions included with the product.

 Bidet BB-2000 Instructions for Use

1. The “Nozzle Selection” knob has three positions for better water direction. Choose the one that fits you better: Nozzle Cleaning (left), Butt Cleaning (center), and Women Cleaning (right).

2. Slowly turn the “Water Pressure” knob to the right until it reaches the comfortable pressure required for cleaning. Adjust the pressure to your comfort level.

WARNING: Be careful to turn the “Water Pressure” knob very slowly until the comfortable pressure is reached.

3. “Self-Cleaning System”: after using the bidet turn the “Nozzle Selection” knob to the left to activate the “Self-Cleaning System” that will clean the nozzle surfaces. Then, turn the “Water Pressure” knob all the way to the right for a few seconds and turn it off again.

Back to Top