Bidet BB-500 Installation Instructions:

1. Remove the toilet seat and cover using a flat screwdriver.

2. Turn off the incoming water to the toilet at the valve on the wall, and drain the toilet's water tank.  Disconnect the existing hose or pipe at the toilet tank, not at the valve on the wall.

3. Connect and hand tighten the "Plastic T Connector" to the bottom of the toilet tank.

4. Connect the existing water hose or pipe to the other end of the "Plastic T Connector" placing the 7/8" "Black Rubber Washer" inside the end of the hose or pipe.

5. Place the large "Black Rubber Washers" on the holes of the toilet and set the bidet on the toilet, aligning the "Sliding Seat Adjusters" to the holes of the toilet bowl, and using the existing bolts and nuts, replace the toilet seat and cover fastening the bolts and nuts with a wrench and flat screwdriver.

6. Once you have finished setting the bidet, unroll the "Plastic Water Tube" included in the box and cut the required length to connect the bidet to the "Plastic T Connector" in the toilet tank.  Proceed to install it loosening the nuts of the bidet and connecting the tube by hand to the bidet and to the "Plastic T Connector" on the toilet tank.

7. After installation, open the water valve and let the water pass through the system.

8. Slowly push the bidet's lever downward to open the valve and remove the stagnant water.

9. Select the desired position of the "Nozzle", it has three for your convinience.

For more details, see instructions included with the product.

Bidet BB-500 Instructions for Use:

1. Once seated on the toilet, push the "Water Pressure Lever" slowly pushing the lever downward until you reach a comfortable pressure for required cleanness.  Adjust pressure to your comfort level.

WARNING: Be careful to push the "Water Pressure Lever" very slowly until the comfortable pressure is reached.

2. The "Nozzle" has three positions for better water direction. Choose the one that fits you better.